Resources

Category: Track

Drill

Flying

The Flying drill is a time/speed measure from point A to point B with optional splits in-between. Note that a Fly uses a moving start and requires 2 timing gates. Step-By-Step Instructions Select your timing equipment: Dashr | Silver Dashr | Blue Dashr | Blue For 2-point starts we typically suggest using the Flying drill. […]

Drill

Lap

The Lap drill can be used for any application that requires the start and stop at the same location. This drill can use a stationary or moving start and requires 1 timing gate. Additional gates can be added if splits within a lap are desired. Step-By-Step Instructions Stationary Starts Moving Starts

Drill

Dash

The Dash is a time/speed measure from point A to point B with optional splits in-between. Note that Dash uses a stationary start and requires 2 timing gates. Step-By-Step Instructions For 2-point starts we typically suggest using the Flying drill. See demonstrative video below.